Airflow and energy
Imbalance or belt faults can reduce airflow and raise energy use.
Fan imbalance, belt problems and motor degradation that cause airflow issues or higher energy use are flagged early.
When impellers, belts or bearings degrade, fans and blowers need more load for the same airflow. SV500 uses Electrical Signature Analysis (ESA) to screen fan drive motors and variable frequency drives (VFDs) for early changes.
Fan degradation leads to airflow problems and higher power use.
Imbalance or belt faults can reduce airflow and raise energy use.
Many units sit in ceilings or on roofs, so rounds alone are limited.
Analyzes the VFD’s voltage output and current waveforms to diagnose faults in rectifier diodes, DC-link capacitors, and switching semiconductors (SCRs or IGBTs). Also analyzes the condition of power supply and power quality of the VFD.
Without installing additional sensors on the equipment, analyzes the voltage and current waveforms supplied to the motor to diagnose mechanical faults (Cavitation, Soft Foot, Bearing, Vibration, etc.), electrical faults (Stator, Cable connection, Heat, Noise, etc.) and Load fluctuation fault.
For power quality diagnosis, saves power quality indicators such as voltage, current, interruptions, sags, harmonics, etc. in trend data.
Performs all diagnostic analysis directly on the edge device. Built-in memory and storage—2GB DDR, 8GB eMMC, and SD card support up to 256GB—enable long-term storage of diagnostic data and waveforms without transmitting them to a server. The built-in web-based UI/UX provides access to real-time data, diagnostic result of the equipment, diagnostic data of the power quality, alarm events, reports and etc. without a separate server.
Narrow down likely causes of lower airflow and higher power early.
If changes persist, inspect belts and impellers.
Basis to review filter replacement and damper operation.
Compare many fans on the same basis.
Continuous monitoring and early detection support availability, maintenance and energy efficiency.
Illustrative ranges, not verified SV500 results. Actual outcomes depend on site conditions and corrective actions; PoC validation is required.
Name the one that matters most and we will set out the diagnostics and measurement points for it.
Request a demo