Phase imbalance and overload
Non-linear loads and added equipment shift per-phase loading and can shorten equipment life.
Phase imbalance, overload and abnormal current draw in critical building systems are detected at the panel.
Switchboards are where many critical building loads converge. SV500 analyzes three-phase voltage and current at each feeder and records imbalance, overload and power quality events as trends.
Load problems on critical equipment are hard to catch with walk-around inspections alone.
Non-linear loads and added equipment shift per-phase loading and can shorten equipment life.
Equipment spread across mechanical and electrical rooms makes continuous change easy to miss on rounds.
SV500 analyzes three-phase voltage and current at the switchboard to assess load condition.
Compares supply-side voltage imbalance with load-side current imbalance at the same time to narrow down the source.
Records feeder current and load ratio against ratings. Pinpointing a specific machine requires its own measurement point.
Logs sags, swells, momentary outages and overcurrent with timestamps; the causing load is confirmed with operating records.
Machine learning learns each asset's normal condition and judges its status with load-dependent adaptive thresholds, rather than fixed limits.
Check diagnostic status in real time on the device's built-in web dashboard without a site visit, and connect to higher-level systems such as BMS or SCADA over Modbus TCP/RTU. Additional interfaces such as MQTT depend on the project configuration.
Send maintenance staff to problem equipment first and favor planned maintenance.
Find feeders with high peaks or phase bias as a basis for load rebalancing.
Coverage follows the measurement channels and feeder layout.
Compare health grades across equipment on one common basis.
Continuous monitoring and early detection support availability, maintenance and energy efficiency.
Illustrative ranges, not verified SV500 results. Actual outcomes depend on site conditions and corrective actions; PoC validation is required.
Name the one that matters most and we will set out the diagnostics and measurement points for it.
Request a demo