edgeSV is the equipment health brand of NTEK System Co., Ltd. ntek@nteksys.com
edgeSV
Request a demo
Overview

Drainage and sump pumps sit idle for long periods but must start instantly during rain or leaks. SV500 accumulates start-up current and load patterns to screen standby pumps that need attention.

Target equipment
Sump/drainage pumpsPump drive motorsStandby pumps & panels
Key challenges

Operating challenges

Faults in rarely run pumps are discovered late.

01

Infrequent operation

A pump that looks normal on standby can reveal problems only when it actually starts.

02

Failures found on rainy days

A standby pump fault may only surface at the moment it is needed.

How SV500 diagnoses

What SV500 detects

SV500 analyzes the pump motor's electrical signals at start-up and in operation.

01

Start current and load

Compares inrush current and time to reach normal operation between test starts and real runs at similar water levels.

02

Motor insulation, bearings

Insulation wear can appear first in current imbalance and leakage current. If a trend appears, confirm by insulation resistance test and pump lift-out inspection.

03

Imbalance in operation

Separates phase current imbalance from supply voltage imbalance. If it persists, check insulation resistance and cable joints.

04

Adaptive thresholds

Machine learning learns each asset's normal condition and judges its status with load-dependent adaptive thresholds, rather than fixed limits.

05

Web dashboard and integration

Check diagnostic status in real time on the device's built-in web dashboard without a site visit, and connect to higher-level systems such as BMS or SCADA over Modbus TCP/RTU. Additional interfaces such as MQTT depend on the project configuration.

Expected benefits

Benefits

Pick the pumps to service before the rainy season and plan maintenance.

01

Select pumps to inspect

Compare test-start current and running load under similar conditions.

02

Flood-risk preparation

Service the units that need attention before the rains.

03

Maintenance priorities

Compare health grades across equipment on one common basis.

Operational Impact of edgeSV

Continuous monitoring and early detection support availability, maintenance and energy efficiency.

20~40% Reduction in unplanned downtime
10~25% Maintenance cost savings
5~15% Energy savings
10~20% Longer equipment life

Illustrative ranges, not verified SV500 results. Actual outcomes depend on site conditions and corrective actions; PoC validation is required.

Which asset comes first?

Name the one that matters most and we will set out the diagnostics and measurement points for it.

Request a demo