Schedule-based operation
Degradation and changing conditions accumulate in power use without triggering a fault alarm.
Inefficiency caused by degrading equipment is identified from actual operating behavior rather than schedule-based assumptions.
Efficiency loss can show up in power use before any fault alarm. SV500 compares power, power factor and load ratio under the same operating conditions to find candidates for inefficiency.
Operating schedules alone do not reflect actual equipment condition.
Degradation and changing conditions accumulate in power use without triggering a fault alarm.
Without a baseline for equal-load periods, degradation-driven waste stays buried in energy costs.
SV500 analyzes power use and condition trends of equipment together.
Compares power, power factor and load ratio under like conditions. Higher power at the same load is a candidate, judged with throughput data.
Aggregates energy, peak demand, power factor and harmonics per feeder over time to rank improvements. Billing meters remain separate.
If current frequency components shift too, suspect wear; if only power changes, check operating conditions first.
Machine learning learns each asset's normal condition and judges its status with load-dependent adaptive thresholds, rather than fixed limits.
Check diagnostic status in real time on the device's built-in web dashboard without a site visit, and connect to higher-level systems such as BMS or SCADA over Modbus TCP/RTU. Additional interfaces such as MQTT depend on the project configuration.
Choose improvement targets from real operating records and verify the results.
Pick equipment whose power rose through wear and review repair and efficiency together.
Confirm results with power trends before and after an action.
Compare health grades across equipment on one common basis.
Continuous monitoring and early detection support availability, maintenance and energy efficiency.
Illustrative ranges, not verified SV500 results. Actual outcomes depend on site conditions and corrective actions; PoC validation is required.
Name the one that matters most and we will set out the diagnostics and measurement points for it.
Request a demo