Linked to main plant
Desulfurization, dust-collection and denitrification auxiliaries are linked to the main plant, so faults can affect operation.
FGD slurry pumps, ESP and baghouse fans and SCR auxiliaries are covered alongside the main plant.
Desulfurization slurry pumps, dust-collector and baghouse fans, and denitrification auxiliaries run continuously with the main plant. SV500 uses electrical signature analysis (ESA) to track current and load per pump or fan and screen for clogging, wear and aging.
Environmental auxiliaries are tied to the main plant and easily become monitoring blind spots.
Desulfurization, dust-collection and denitrification auxiliaries are linked to the main plant, so faults can affect operation.
Auxiliaries are easily left out of condition monitoring, so changes and events need continuous recording.
SV500 measures current and load separately for each pump, fan and motor.
Compares current and power for similar slurry concentration and flow. Load rises with concentration, so process data is needed to separate it from wear.
Compares fan motor current at the same speed and differential pressure. Baghouse clogging shows with rising pressure, so check the gauge too.
Normal load differs by unit, so SV500 keeps a separate baseline for each rather than one shared standard.
Machine learning learns each asset's normal condition and judges its status with load-dependent adaptive thresholds, rather than fixed limits.
Check diagnostic status in real time on the device's built-in web dashboard without a site visit, and connect to higher-level systems such as BMS or SCADA over Modbus TCP/RTU. Additional interfaces such as MQTT depend on the project configuration.
Screening auxiliary fault candidates early lets crews inspect them first in planned outages.
Screens inspection targets before equipment stops.
Side-by-side views help decide crew deployment.
Compares health grades on one basis to set inspection order.
SV500 meters slurry pumps, dust-collector fans and denitrification motors separately against per-unit baselines. Emissions, reagent state, filter pressure drop and slurry properties must be judged with process measurements.
Name the one that matters most and we will set out the diagnostics and measurement points for it.
Request a demo