edgeSV is the equipment health brand of NTEK System Co., Ltd. ntek@nteksys.com
edgeSV
Request a demo
Overview

Inflow pumps and lift pumps raise sewage to the treatment facility. In this scenario SV500 measures and analyzes the three-phase voltage and current signals of the pump drive motors with PTs and CTs in the control panel to diagnose the condition of the pumps and motors without attaching sensors to the pump body underwater.

Target equipment
Inflow pumpsSubmersible pump drive motorsLift pumps

Operating challenges

Submersible pumps sit underwater, so it is hard to check their condition directly during operation.

01

Equipment where sensors are hard to attach

Yorkshire Water in the UK regards submersible sewage pumps and screw pumps as critical equipment on which ordinary vibration sensors are hard to use, and monitors them with electrical signals read at the motor control panel.

02

Faults not visible until the pump is lifted

At Northern Ireland Water, a submersible pump in which electrical signal analysis detected an abnormality was lifted and found to have its connection to the discharge pipe secured with only 1 of 8 bolts.

What SV500 detects

01

VFD Status Diagnostics

Analyzes VFD input/output voltage and current waveforms to assess rectifier diodes, DC-link capacitors, IGBTs, and the condition of the power supply and power quality.

02

Motor Status Diagnostics

Analyzes motor voltage and current signals without additional equipment-mounted sensors, screening mechanical faults (cavitation, bearings, vibration), electrical faults (stator, cable connections, heat), and load fluctuations.

03

Power Quality Diagnostics

Records and analyzes voltage, current, interruptions, sags, swells, harmonics, and trends to identify power quality abnormalities.

04

Edge AI Device

Performs diagnostic analysis and stores waveforms and results locally. The built-in web interface provides real-time measurements, equipment diagnostics, power quality, events, and reports.

Benefits

Abnormalities in underwater pumps can be identified early without lifting them, so maintenance can be planned.

01

Early detection of potential failures

Detects potential failures early to minimize unexpected incidents and risk.

02

Optimized maintenance schedules

Diagnostic data helps predict and optimize maintenance schedules.

03

Lower cost and downtime

Higher operating efficiency helps reduce energy consumption, maintenance cost and downtime.

Operational Impact of edgeSV

Continuous monitoring and early detection support availability, maintenance and energy efficiency.

20~40% Less unplanned downtime
10~25% Maintenance cost savings
5~15% Energy savings
10~20% Longer equipment life

Indicative ranges only; actual results depend on site conditions and corrective actions.

Which asset comes first?

Name the one that matters most and we will set out the diagnostics and measurement points for it.

Request a demo