A large share of power use
According to the Seoul Water Reclamation Facilities Corporation, sewage inflow pumps and blowers account for about 60% of the total power use of a wastewater treatment plant.
Blower motors, among the largest loads in a treatment plant, are watched for degradation.
Aeration blowers blow air into the bioreactor so that microorganisms can treat the sewage. In this scenario SV500 analyzes the voltage and current signals of the motors and VFDs that drive the blowers to detect abnormalities in the blowers and motors, and also measures power and energy.
Blowers are essential to the treatment process and also consume a lot of power.
According to the Seoul Water Reclamation Facilities Corporation, sewage inflow pumps and blowers account for about 60% of the total power use of a wastewater treatment plant.
In an aeration rotor case at Anglian Water in the UK, electrical signal analysis detected signs of mechanical unbalance and looseness, and inspection found a damaged coupling between the motor and the gearbox.
Analyzes VFD input/output voltage and current waveforms to assess rectifier diodes, DC-link capacitors, IGBTs, and the condition of the power supply and power quality.
Analyzes motor voltage and current signals without additional equipment-mounted sensors, screening mechanical faults (cavitation, bearings, vibration), electrical faults (stator, cable connections, heat), and load fluctuations.
Records and analyzes voltage, current, interruptions, sags, swells, harmonics, and trends to identify power quality abnormalities.
Performs diagnostic analysis and stores waveforms and results locally. The built-in web interface provides real-time measurements, equipment diagnostics, power quality, events, and reports.
Abnormalities in blowers can be identified early, and the power use of each machine can be checked at the same time.
Detects potential failures early to minimize unexpected incidents and risk.
Diagnostic data helps predict and optimize maintenance schedules.
Higher operating efficiency helps reduce energy consumption, maintenance cost and downtime.
Continuous monitoring and early detection support availability, maintenance and energy efficiency.
Indicative ranges only; actual results depend on site conditions and corrective actions.
Name the one that matters most and we will set out the diagnostics and measurement points for it.
Request a demo