edgeSV is the equipment health brand of NTEK System Co., Ltd. ntek@nteksys.com
edgeSV
Request a demo
Overview

Dock levelers and doors run intensively during loading windows. SV500 applies Electrical Signature Analysis (ESA) to drive-motor signals and logs load changes, screening for jamming or rising friction before an emergency stop.

Target equipment
Leveler pump motorDoor motorDock seal/lift drive
Key challenges

Operating challenges

One stalled dock unit can back up loading and slow the whole logistics flow.

01

Loading delays

Dock equipment faults delay loading and unloading, directly affecting uptime and maintenance scheduling.

02

Hard-to-see motor condition

Leveler and door motor condition is difficult to check routinely, so changes during operation need continuous logging.

What SV500 detects

01

VFD Status Diagnostics

Analyzes the VFD input/output voltage and current waveforms to identify faults in rectifier diodes, DC-link capacitors and switching devices (SCRs or IGBTs). Also monitors power-supply condition and power quality.

02

Motor Status Diagnostics

Analyzes motor voltage and current without additional equipment-mounted sensors. Screens mechanical issues (cavitation, soft foot, bearings and vibration), electrical issues (stator, connections, heat and noise), and load fluctuations.

03

Power Quality Status Diagnostics

Learns normal power-quality patterns and evaluates real-time deviations. Tracks voltage, current, interruptions, sags and harmonics to identify abnormal conditions.

04

Edge AI Server

Performs diagnostic analysis directly on SV500. Built-in storage (8GB eMMC and up to 256GB SD) retains waveforms and diagnostic data. Its web interface shows real-time values, equipment status, power quality, alarms, events and reports.

Expected benefits

Benefits

Schedule maintenance in low-volume periods and inspect the riskiest units first.

01

Fewer loading delays

Spot docks with lengthening cycle times and inspect them before work piles up.

02

Pre-failure checks

Use start-up behavior trends to shift from repair to planned inspection.

03

Data-driven priorities

Compares status grades and trends on one scale so scarce maintenance staff go to the highest-risk assets first.

Operational Impact of edgeSV

Continuous monitoring and early detection support availability, maintenance and energy efficiency.

20–40% Unplanned downtime
10–25% Maintenance cost
5–15% Energy savings
10–20% Equipment life

Illustrative ranges only; not verified SV500 performance. Actual results depend on equipment, site conditions and corrective actions.

Which asset comes first?

Name the one that matters most and we will set out the diagnostics and measurement points for it.

Request a demo